Arson Certification Test

Testing will be conducted in an environment acceptable to the testing participants. 100 percent accuracy is required in all three (3) tests. No more than one (1) re-test for any failed portion of this proficiency test shall be permitted within any twenty-four (24) hour period. There will be three areas of testing and there will be a total of 5 different accelerants used for the Arson Certification Test.

  • Gasoline
  • Alcohol
  • Diesel fuel
  • Kerosene
  • Lighter fluid

The three tests covered are

  • Basic Scent Discrimination
  • Mixed Matrix Scent Discrimination
  • Sample Location

Test 1 - Basic Scent Discrimination

Five samples shall be prepared as listed for this test. The amount of each individual sample shall be approximately one-half (1/2) pint of debris. Placed approx. 4 feet apart. Each sample shall be burned with a propane torch until the contents are partially charred.

  1. Burned Softwood (i.e. Pine, Fir)
  2. Burned High-Density Polyethylene (i.e. Plastic Milk Jug)
  3. Burned Styrofoam
  4. Burned Carpet and Pad
  5. 5ul of 50 percent weathered (diluted) accelerant (evaluators choice) on a cotton ball.

It will be the handler’s responsibility to inform the administrator upon which sample the canine has alerted.

Test 2 - Mixed Matrix Scent Discrimination

Five samples shall be prepared as listed combining all of the following. The amount of each individual sample shall be approximately one-half (1/2) pint of debris.

  1. Softwood (i.e. Pine, Fir)
  2. High Density Polyethylene (i.e. Plastic Milk Jug)
  3. Styrofoam
  4. Carpet and pad

The mixed matrix shall be burned with a propane torch until all of the individual contents are partially charred. After the matrix has cooled to ambient temperature, the administrator will apply 5ul of 50 percent weathered (diluted) accelerant (evaluators choice) to at least one (1), and no more than three (3) of the samples. It will be the handler’s responsibility to inform the administrator upon which sample(s) the canine has alerted.

The handler will not know prior to testing which sample(s) are positive.

Test 3 - Sample Location

Two (2) common 1 inch X 4 inch pine boards, 24 inches in length, will be divided with pencil marks into three (3) sections approximately eight (8) inches each. The sections will be numbered 1 through 6.

The boards shall be placed at least one (1) foot apart. 5ul of 50 percent weathered accelerant shall be placed near the center of one of the numbered sections of either board and allowed to dry for 30 min.

The Canine Team shall be offered the wood to examine and it is the responsibility of the handler to inform the administrator(s) upon which section the canine has indicated.

Note: Any false indication is considered a failure to locate during any part of the test.

Trained by civilian, law enforcement and military personnel to meet the exact specifications required.

We provide the highest quality working dogs to do any job required.


Our testing and dog selection is unmatched


Providing state of the art patrol, detection and tactial training

We Also Provide

  • Narcotics/Explosives Detection
  • Sport and Personal Protection
  • Tracking/Trailing Utilization
  • Patrol and Special Operation Utilization
  • Bed Bug and Arson Detection

Our certifications of Police Dogs are on a pass/fail basis.

No point will be awarded and competition/awards will be prohibited. The certification will be based on the ability to perform the tasks set forth by the procedures adopted by Bullock's K-9 Training.

If your department requires a points scale we can accommodate that into our training for you.

Follow us on social